|
|
|
|
|
Creative Thermal Solution
PC-A20 has two heat zones, one zone for motherboard, graphics card and optical drives, and one zone for 3.5” HDD and power supply unit. To separate the heat sources for better thermal solution.
|
|
|
|
|
|
|
|
|
|
PC-A20 has fitted a 140mm intake fan, The fan can output high air flow volume with lower RPM to push the cold air through the HDD rack. It can be adjust by the three-speed fan speed controller, factory setting to Middle (980RPM), user can adjust the fan speed to suit.。(140mm fan speed @800-980-1200RPM)
|
|
|
|
|
|
|
|
|
|
There is a 120mm exhaust fan at the rear to draw the hot air out, and a 140mm PCI cooler fan next to the PCI slots. Their speed can be adjust by the three-speed fan controller, (120mm 1024 - 1240 -1500RPM; 140mm 800 - 980 - 1200RPM) factory setting to Middle (120mm@1240RPM; 140mm@980RPM), user can adjust the fan speed to suit.
|
|
|
|
|
|
|
|
|
|
PC-A20 has fitted a 120mm fan on the graphics card holder to cool the memory and north bridge chip set. Fan speed can be adjust by the three-speed fan controller,factory setting to middle (1240RPM), user can adjust the fan speed to suit.
|
|
|
|
|
|
|
|
|
|
Power supply unit located at the lower part of the chassis, and it can get the cool air from the bottom of the chassis. Ideal for keep power supply in lower temperature to keep in best output performance, also keep the components cold to extend the life cycle.
|
|
|
|
|
|
|
|
|
|
There is a panel between HDD and PSU sections, there is space for a 120mm fan for improve air flow.
|
|
|
|
|
|
|
|
|
|
There are opening for water tubes on rear of the top cover. Ideal for user who would like to fit liquid cooling system into PC-A20.
|
|
|
|
|
|
<PREV
|
|
NEXT>
|
| |
|
|
|
|
|
|
|
|
