Chassis For ATX| Quality | Design | Feature | Silent | Thermal | Friendly | Specification | Accessories

Creative Thermal Solution   PC-V series chassis has two heat zones, one zone for motherboard, graphics card and optical drives, and one zone for 3.5” HDD and power supply unit. To separate the heat sources for better thermal solution.               Lian Li fitted a 120mm intake fan on PC-V1000Z, The fan can output high air flow volume  with lower RPM to push the cold air through the HDD rack. It can be adjust by the three-speed fan controller, factory setting to meddle (1240RPM), user can adjust the fan speed to suit.               The case front fitted with vented 5.25” bezels, allow the cold air to enter the chassis, there are air filter on the bezel to stop dust entering the chassis.               There is a 120mm exhaust fan at the rear to draw the hot air out, and improve the air flow inside the chassis. It can be controlled by the three-speed fan controller, factory setting to Middle ( 1240RPM), user can adjust to suit.             PC-V1000Z Features a three-speed fan controller, user can adjust the fan speed to get the best balance between  silent and cooling. Factory setting to Mid Speed (12cm:1240RPM; 14cm:980RPM), user can adjust the fan speed to suit. (12cm:1020~1240~1500RPM; 14cm:800~980~1180RPM)               Where air enter the chassis, there is a need for an air filter to hold the dust. PC-V1000Z fitted a washable air filter, it can easy remove from the fan unit, no tool required, and it is recyclable.             There are  vent holes next to the PCI bracket, it can improve the cooling issue at the lower part of the motherboard, there are optional accessories as BS-03, BS-06 to improve thermal for graphics card.                 Today’s motherboards using heat pipe solution to solve the heating problem, therefore the all new V series change the motherboard back to up-right position, and there are opening on he motherboard tray allow to air to cool the rear of the motherboard.             PC-V1000Z Features a 140mm fan next to the graphics card to cool the graphics cards and north bridge chip set. It can be connected to the three-speed fan controller, factory setting to Middle (980RPM), user can adjust the fan speed to suit.               Power supply unit located at the lower part of the chassis, and it can get the cool air from the bottom of the chassis. Ideal for keep power supply in lower temperature to keep in best output performance, also keep the components cold to extend the life cycle.           There are two openings on the rear of the top cover, for user who want to use liquid cooling system in PC-V1000Z. There are also two dust-free cover to cover up the openings.    <Prev                Next>